型號 | 實時采樣率等效采樣 | 帶寬 | 存儲 | 簡介 | 價格 |
DSO1050C | 250MS/s 實時 50GS/s 等效 | 50MHz | 32K | 示波器+頻譜+萬用表 | 3200元 |
DSO1060 | 250MS/s 實時 50GS/s 等效 | 50MHz | 32K | 示波器+頻譜+6000計數萬用表 | 3600元 |
DSO8060 | 250MS/s 實時 50GS/s 等效 | 50MHz | 32K | 示波器+任意信號源+頻率計數 器+頻譜分析+萬用表 | 3900元 |
DSO1200 | 500MS/s 實時 50GS/s 等效 | 200MHz | 32K | 示波器+頻譜+6000計數萬用表 | 4900元 |
| | | | | |
DSO1062B | 1GS/s 實時 25GS/s 等效 | 60MHz | 1MB | 示波器+頻譜+6000計數萬用表 | 4900元 |
DSO1102B | 1GS/s 實時 25GS/s 等效 | 100MHz | 1MB | 示波器+頻譜+6000計數萬用表 | 5400元 |
DSO1202B | 1GS/s 實時 25GS/s 等效 | 200MHz | 1MB | 示波器+頻譜+6000計數萬用表 | 5900元 |
| | | | | |
DSO1062S | 1GS/s 實時 25GS/s 等效 | 60MHz | 1MB | 隔離示波器+頻譜+萬用表 | 5400元 |
DSO1122S | 1GS/s 實時 25GS/s 等效 | 120MHz | 1MB | 隔離示波器+頻譜+萬用表 | 5600元 |
DSO1152S | 1GS/s 實時 25GS/s 等效 | 150MHz | 1MB | 隔離示波器+頻譜+萬用表 | 5800元 |
DSO1202S | 1GS/s 實時 25GS/s 等效 | 200MHz | 1MB | 隔離示波器+頻譜+萬用表 | 5980元 |
| | | | | |
DSO1062BV | 1GS/s 實時 25GS/s 等效 | 60MHz | 1MB | 示波器+頻譜+萬用表(內置視頻幫助,,2G SD卡 | 4800元 |
DSO1102BV | 1GS/s 實時 25GS/s 等效 | 120MHz | 1MB | 示波器+頻譜+萬用表(內置視頻幫助,,2G SD卡 | 4980元 |
DSO1202BV | 1GS/s 實時 25GS/s 等效 | 200MHz | 1MB | 示波器+頻譜+萬用表(內置視頻幫助,2G SD卡 | 5900元 |
| | | | | |
DSO1062CV | 1GS/s 實時 25GS/s 等效 | 60MHz | 40K | 示波器+頻譜+萬用表(內置視頻幫助,,2G SD卡 | 4600元 |
DSO1102CV | 1GS/s 實時 25GS/s 等效 | 120MHz | 40K | 示波器+頻譜+萬用表(內置視頻幫助,,2G SD卡 | 4900元 |
DSO1202CV | 1GS/s 實時 25GS/s 等效 | 200MHz | 40K | 示波器+頻譜+萬用表(內置視頻幫助,2G SD卡 | 5600元 |
| | | | | |
| |
| |
| |
連接到計算機上就變成虛擬示波器 | |
| |
| |
| |
| |
| |
| |
| |
Model | DSO1202S | DSO1122S | DSO1062S |
Oscilloscope mode | |||
Bandwidth | 200MHz | 120MHz | 60MHz |
Real-time Sample Rate | 1GSa/s | ||
Equivalent Sample Rate | 25GSa/s | ||
SEC/DIV Range | 2nS/div-2000S/div (in a 2, 4, 8 sequence) | ||
Delay Time Accuracy | 500ps | ||
Vertical | |||
A/D Converter | 8-bit resolution | ||
VOLTS/DIV Range | 2mV/div~5V/div at input BNC | ||
Position Range | ±50V(5V/div),±40V(2V/div~500mV/div), ±2V(200mV/div~50mV/div)±400mV(20mV/div~2mV/div) | ||
Record Length | Single-channel: Maximum 2M; Dual-channel:Maximum 1M | ||
Trigger | |||
Trigger Sensitivity (Edge Trigger Type) | DC: CH1/CH2(Typical) 1div from DC to 10MHz;1.5div from 10MHz to Full AC: Attenuates signals below 10Hz HF Reject: Attenuates signals above 80kHz LF Reject: Attenuates signals below 150kHz Noise Reject: Reduces trigger sensitivity | ||
Trigger Level Range | CH1,CH2: ±8 divisions from center of screen | ||
Trigger Level Accuracy, typical (Accuracy is for signals having rise and fall times ≥20ns) | CH1,CH2: ±(0.3div×V/div) (within ±4 divisions from center of screen) | ||
Holdoff Range | 100ns-10s | ||
Trigger Type | |||
Edge | Trigger on the rising or falling edge | ||
Pulse Width | Trigger (when >,<,=,≠) on positive or negative pulses Pulse Width Range: 20ns-10s | ||
Video | Trigger on an NTSC, PAL, or SECAM standard video signal Line Range: 1-525 (NTSC), 1-625 (PAL/SECAM) | ||
Slope | Trigger (when >,<,=,≠) on a positive or negative slope Set Time: 20ns–10s | ||
Overtime | from the rising or falling edge Set Time: 20ns-10s | ||
Alternate | Internal trigger on edge, pulse width, video or slope | ||
Measurement | |||
Cursors | Manual: The difference between voltage cursors △V; the difference between time cursors △T; 1/△T calculated by Hz. Tracing: The voltage and time at a waveform point | ||
Automatic | Pk-Pk, Max, Min, Mean, Cyc RMS, Frequency, Period, Rise Time, Fall Time, Positive Width, Negative Width | ||
Meter Mode | |||
Max.Resolution | 6,000 Counts | ||
DMM Testing Modes | Voltage, Current, Resistance, Capacitance,Diode & Continuity | ||
Max. Input Voltage | AC: 600V, DC: 800V | ||
Max. Input Current | AC: 10A, DC: 10A | ||
Input Impedance | 10 MΩ | ||
Isolation | |||
The float voltage between BNC and Ground | 600V CATIII, 1000V CAT II | ||
The float voltage between each Channel | 600V CATIII, 1000V CAT II | ||
The float voltage between Multimeter and Ground | 1000V | ||
between input Ports directly | 400V CAT II | ||
Input by 10:1 probe | 600V CATIII, 1000V CAT II | ||
The Max input voltage of Multimeter | DC 800V,AC 600V | ||
Display | |||
Type | Right angle 5.6 16-digit color LCD | ||
Resolution | 640*480 dots | ||
Contrast | 16 gears, with the progress bar to show adjustment | ||
Interface | USB host and USB slave, Lan Optional | ||
Power Supply | |||
Voltage | DC Input:12--17VDC, 2000mA | ||
Mechanical | |||
Size | 245 x 163 x 52 (mm) | ||
Weight | 1.3KG (exclusive of packing and accessories) |